Double Braid Class I Eye Splice. SAMSON SPLICING INSTRUCTIONS. Class I ropes are made from any or all of the ...
SAMSON SPLICING INSTRUCTIONS ... (2 wire fid lengths) from end of rope and mark. ... Note nature of cover braid.
refer to “Special Tips for. Splicing Double Braid. Class I”, on th last page of these splice instructions. 1 fid OR. 2 wire fids.
Pull the wire braid back over the outer jacket. Trim off ... 8. Brown. 5. Note: Wiring instructions for 568B method.
Class I Double Braid Eye Splice*. Instructions for New Rope. Class I Double Braided ropes are made from any or all of ...
Braided Hose-End Fitting Instructions. 1. 2. 4. 3. 5. 6 ... threads and braided wire, just a bit to help it settle without friction ...
Find the wires or cable that looks just like the ones attached to your pickup. ... NOTE: BRAIDED WIRE SHIELDING.
1/4” trim tool. Remove trimmed jacket from cable. Evenly flare and separate the wire braid. Fold back flared wire braid.
4 Flare the wire braid out. Fold the wire braid back over the jacket and ATUM (Fig 2). ... Termination Instructions.
2.0 Ground Braid Installation. 2.1 Position preformed ground braid @(Figure 2) with long end along cable jacket.
Pre-tin the end(s) of the braid as directed in your work instructions.) • Strip one end of the ground wire to remove 1/4 to ...
CABLE ASSEMBLY. INSTRUCTIONS. Crimp. All braid wires on outside of inner ferrule. Crimp. CONNECTOR BODY.
Braided Safety Blue & Hivee Eye Splice. 19 ... Soaking the section of used rope to be spliced in water will loosen and lu- ... Before starting, it is a good idea to read through the directions so you.
Assembly Instructions: 1. Thread the ... Crimp the #4 Stud Lug (9) onto the end of the braided grounding wire. 4.
S-100-X Assembly Instructions. High Voltage ... pull the inner insulated wire through, leaving the grounding braid intact.
This brochure is an overview of the cable assembly instructions for the ... Tinned copper wire braid, overlap 90%. 6.
insulation from the inner wire. . Cut wire to desired length. Step1. Push the braided wire in accordance with the direction ...
Instructions: 1. ... Insert the “ring” of copper braiding over one of the cable ends and again, slide it down the cable.
and braid, per instructions of commercially available drop cable preparation tool ( Fig. 1). 4. Ensure the center conductor ...
1. Applications. TBX-4LC. Installation Instructions. 2 ... Separate braid strands and pull cable through open- ing in braid.